totalhu.blogg.se - What is winretools drive

Unfortunately, I don't know how to tell if the ".

ST500LT012-9WS1 (Disk 0, with 5 volumes listed).

SSD PM830 mSATA (Disk 1, with 1 volume listed).

Note that this system has two entries in Device Manager under Disk Drives as follows:

\\?\Volume\ was not optimized because an error was encountered:.

In File Explorer, I click on Drive C Properties -> Tools -> Optimize. Your disk is a GPT because of the EFI system partition and therefore you would need to use the diskpart convert GPT command shown in the guide.I have a Dell Inspiron Ultrabook running Windows 8.1 (64-bit). 4) You should also delete or clean up your hosts file. Right-click on the WinTools folder (if it exists) and Delete it. Open My Computer, Drive C, Program Files, Common Files. BC has a guide for doing a clean install. 3) Delete the WinTools folder and all associated files.

The downside is you would need to reinstall all your programs. Just FYI a clean install of Windows 10 is always preferable to an upgraded system. If you decide to delete the partitions I can provide the steps using Partition Wizard. nomenclature) is an SSD and the second disk (Drive 1) is a hard disk. One partition that is not normally shown in Disk Management it the MSR partition after the System Partition which in Windows 10 is 16MB but may be different on your disk because it was an upgrade. 900 MB WinRE Tools - Im pretty sure this is a standard set of Windows tools. You would need to do this with a Partition Manager like Partition Wizard and I would not do it unless your personal data was backed up to another device. That could also be deleted but this can be helpful because it lets you check your hardware at boot. The 40MB partition is for Dell Diagnostics. After deleting them you could move/resize your C: partition after moving the 450MB partition.

I believe your could delete both the PRB and 750MB partitions. If the drive letters for those partitions are unassigned I don't believe you would get those errors. I would wait for jenae to reply but in the mean time open a command prompt and type the following commands.ĭiskpart Opens the diskpart command prompt